+- AlphaRomeo15 (https://www.alpharomeo15.org)
+-- Forum: Other Weapons (https://www.alpharomeo15.org/Forum-Other-Weapons)
+--- Forum: Edged Weapons (https://www.alpharomeo15.org/Forum-Edged-Weapons)
+--- Thread: s35vn steel (/Thread-s35vn-steel)
s35vn steel - tommag - 12-13-2023
I have a kizer activ bantam that I like and resolved not to abuse. Oh wth, I can pry that splinter out, it's not stuck that bad....snap!
Then, last week I cut a couple wires that weren't hooked up to anything and were in my way. Zzzap, they were still hooked to power and ground. No it has no point and a burnt section near the tang. Looks like it's time to replace it. I like the s35vn steel, not too hard to sharpen and holds an edge reasonably well.
I like a flipper tab as I can't have automatic or spring assist. Drop point suits me as well and I prefer 4-5" blades. I'd go up to $200.
Any recommendations?
RE: s35vn steel - tommag - 12-13-2023
This one seems to fit my requirements, but the flipper tab looks a bit small for old arthritic hands.
https://www.bladehq.com/item--Artisan-Cutlery-Shark-Liner-Lock--85018
RE: s35vn steel - Rampy - 12-13-2023
O like Spyderco & the hole vs a tab
RE: s35vn steel - md65636 - 12-14-2023
I have been running the Spyderco Tenacious as a work knife. I absolutely love it. I did change out the scales for a less aggressive black pair.
https://www.spyderco.com/catalog/details/C122BL/Tenacious-reg-Lightweight-CPM-S35VN/1910
RE: s35vn steel - tommag - 01-11-2024
I ended up getting this one from zero tolerance. I like it so far.
https://www.bladehq.com/item--Zero-Tolerance-0452CF-Flipper-Knife--27354