I have a kizer activ bantam that I like and resolved not to abuse. Oh wth, I can pry that splinter out, it's not stuck that bad....snap!
Then, last week I cut a couple wires that weren't hooked up to anything and were in my way. Zzzap, they were still hooked to power and ground. No it has no point and a burnt section near the tang. Looks like it's time to replace it. I like the s35vn steel, not too hard to sharpen and holds an edge reasonably well.
I like a flipper tab as I can't have automatic or spring assist. Drop point suits me as well and I prefer 4-5" blades. I'd go up to $200.
Any recommendations?
(This post was last modified: 12-13-2023, 07:03 PM by tommag.)
Then, last week I cut a couple wires that weren't hooked up to anything and were in my way. Zzzap, they were still hooked to power and ground. No it has no point and a burnt section near the tang. Looks like it's time to replace it. I like the s35vn steel, not too hard to sharpen and holds an edge reasonably well.
I like a flipper tab as I can't have automatic or spring assist. Drop point suits me as well and I prefer 4-5" blades. I'd go up to $200.
Any recommendations?
