Timney trigger and 80% lowers

2 Replies, 544 Views

Have you tried the trigger in a factory machined lower?

I have almost all 80’s. I have a go/no go block for the fire control pocket, but I’ve never had one fail- and since I’ve been using a router, my pockets look really great.

But I don’t know about trigger pin holes. I wish someone made a jig that would fit from the side and help determine if all the safety and trigger pin holes were within spec.
[-] The following 1 user Likes srjdsmith's post:
  

Messages In This Thread
Timney trigger and 80% lowers - by tommag - 12-11-2023, 11:53 PM
RE: Timney trigger and 80% lowers - by srjdsmith - 12-12-2023, 12:26 AM
RE: Timney trigger and 80% lowers - by tommag - 12-12-2023, 12:42 AM



Users browsing this thread: 4 Guest(s)

Best CLP you can buy!